The Side Marker Lamp Assembly – Rear LH – 1970-1981 Pontiac Firebird restores factory-correct safety lighting on the driver-side quarter panel of every second-gen Bird. Trim Parts molds the housing in UV-stable acrylic, matches GM’s rib detail in the deep-red lens, and pre-installs an 1157 dual-filament socket with sealed pigtail—just plug into the OE harness and bolt up. Mounting bosses line up with both steel and urethane quarters, so the lamp seats flush without shims, keeping water out and brightness in. A vacuum-metalized reflector meets DOT photometrics to keep your Firebird visible at night, while the clear-coat finish resists road grit, chemicals, and sun fade. From base models to Esprit, Formula, and Trans Am, this assembly completes concours restorations, collision repairs, or driver refreshes in a quick ten-minute install.
Auto Metal Direct is a team of true car guys with years of experience in sheet metal reproduction, car restoration and paint/body work. We believe that quality is not subjective! Our mission is to provide the best customer experience for the Ford, Mopar and GM classic car markets - both in products and in service.
Our panels are made from proper gauge steel and include all correct-as-original clips, tabs, flanges, bends and seams. Each time a prototype body panel comes off of a new tooling, we test fit it on a car. The marked up prototype is then used to change and improve the tools, and a new prototype is produced. This procedure might be repeated multiple times but, once the part is finally approved, you can be assured of a quality part.
| Make | Model | Years |
| Pontiac | Firebird | 1970 - 1981 |
| Brand | Trim Parts |
| Height | 7 in |
| Length | 7 in |
| Weight | 1 lbs |
| Width | 7 in |
