Quality reproduction of the original pitman arm designed for 1967 Camaro, Firebird (manual steering) and 1968-69 Camaro with special steering (Z/28) models. Manufactured to exact factory specifications. Each assembly features heat treated components and forging, and precision machining tolerances. Replacing this component improves steering response; reduces wander and vibration. Assembly includes: (1) Pitman Arm, (1) Dust Seal, (1) Castle Nut, (1) Cotter Pin, (1) Grease Fitting. NOTE: Not for use with power steering.
Product Specifications
Stud Dia. Small End Of Taper: 0.59
Sector Shaft Dia.: 1.125
Sector Shaft Spline Large Inner Diameter: 1.04
Length Center to Center: 5.78
Key Way (Male or Female): Male
Off Set: Down
# of Splines: 32
Hardware Included: Yes
Arm Type: Bent
Arm Fixture: Stud
Arm Fixture Stud Thread/Hole Inside Diameter: 1/2-20
Greasable: Yes
Chevrolet Applications:
1967-1967 Chevrolet Camaro (manual steering
1967-1969 Chevrolet Camaro Z28 (302ci engine, with quick ratio steering)
The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
