UMI Performance Trailing Arms, Roto-Joints | 2516-R Camaro 2010-14

UMI Performance Trailing Arms, Roto-Joints | 2516-R Camaro 2010-14

$531.99 kt
Model:3260249
Condition: NEW
Availability:
ARRIVING SOON!
Estimated arrival: 09/29/2020 (If Ordered Today)
Fitment:
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
Shipping Note:Standard Delivery
Qty:

Can't Find your Part?

We'll find it for you. Give us a call at 877.589.9860 and we'll source that discontinued or hard to find part.

Why Choose Us?

No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.

Disclaimer

Camaro Depot always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.


Fits 2010 To 2014 Chevrolet Camaro (All Models)
Fabricated From 1” x 2” Rectangular Tubing
¼” Thick CNC Machined Mounting Plates
CNC Machined DOM Bushing Holders
Spherical Roto-Joints For A Bind Free Performance
Direct Bolt On, Uses OEM Hardware
Durable Powder Coat Finish
Made In The USA

UMI's rear trailing arms for the fifth generation Camaro utilize our Roto-Joint technology for 
a bind free performance and quiet comfortable ride quality. The Roto-Joint design is a pivot 
ball lined with a greaseable delrin race designed to offer 28 degrees of total unrestricted 
movement, more than adequate for a bind free, low friction operation. The Roto-Joint design 
improves performance over the factory rubber and aftermarket polyurethane bushings by 
allowing the suspension to articulate correctly, and provide precision handling. The 
installed UMI Roto-Joint allows rear end free movement when high handling, auto cross or 
road race is a concern while still being a 100% streetable setup. The installed delrin race, 
which lines the spherical ball, absorbs shock and road noise for a quiet and smooth 
operation on any street or track driven vehicle. This trailing arm set is designed to minimize 
wheel hop, maximize caster settings and increase rear end stability. UMI’s trailing arms are 
fabricated from 1” x 2” rectangular tubing and feature ¼” thick CNC machined mounting 
plates and are supplied fully assembled with Roto-Joints. Trailing arms are a direct bolt in 
and installation time is less than an hour using basic hand tools.

Spanner Wrench- This spanner wrench is used for adjusting and disassembling of Roto-
Joints used in all UMI Performance products. Over time if the delrin race inside the Roto-
Joint would wear the spanner wrench is used to tighten the adjusting ring applying more 
pressure to the delrin inside. The spanner wrench is also used to disassemble the Roto-Joint 
for cleaning, inspection and rebuilding.

The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
Make Model Years
Chevrolet Camaro 2010 - 2014

Write a Review

Your Name:

Your Review:

Note: HTML is not translated!

Rating: Bad Good

Ask a question about

UMI Performance Trailing Arms, Roto-Joints | 2516-R Camaro 2010-14:
Your Name:


Your Email:


Question: Note: HTML is not translated!

Related Products
Shipped from Canada
No Brokerage/Duties
Canadian Owned
www.camarodepot.ca 2020