LOW STOCK ALERT!
Units in stock: 2
Ships within 24 - 48 hours
Available for Pickup
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
|Shipping Note:||Standard Delivery|
We'll find it for you. Give us a call at 877.589.9860 and we'll source that discontinued or hard to find part.
No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.
Camaro Depot always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.
Good Quality Reproduction Clutch Fork Boot Black Molded Rubber One Required per Car Fits Big Block or Small Block Cars Rick's brings you this reproduction clutch fork boot to replace a commonly worn Camaro part. The bellhousing to clutch fork rubber boot seals out water and dust by sealing around the clutch fork and the rectangular fork hole in the Camaro clutch bellhousing. Every time you push the clutch pedal in your manual transmission Camaro, the clutch fork boot gets a work out and will eventually tear. Check your Camaro's bellhousing today and order your replacement from Rick's First Generation. NOTE: Camaros with hydraulic throw out bearings may use this boot for the hydraulic lines to pass through as some measure of protection. However, the clutch fork boot will not provide an air tight seal.
|Chevrolet||Camaro||1967 - 1983|
Note: HTML is not translated!
Rating: Bad Good