YES, IT'S IN STOCK!
Units in stock: 11
Ships within 24 - 48 hours
Available for Pickup
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
|Shipping Note:||Standard Delivery|
We'll find it for you. Give us a call at 877.589.9860 and we'll source that discontinued or hard to find part.
No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.
Camaro Depot always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.
Technically Correct Reproduction Retaining Clip Set Hurst Style Correct Diameter & Tensile Strength Retains Various Clutch Linkage Components Set Of 3 The bellcrank assembly in your 1967, 1968, or 1969 Camaro has several components to keep it together, including the push rod retaining clips. Over time, these clips can become brittle and break off, leaving your bellcrank assembly prone to misalignment. Replace your clutch bellcrank push rod mounting clips today. Rick's Camaros offers this set of bellcrank push rod retaining clips, used to hold various clutch linkage components in the bellcrank assembly of your F-Body. This technically correct reproduction set includes three Hurst style retainer clips, with correct diameter and tensile strength. Trust Rick's Camaros for all of your restoration and replacement needs for your 1967, 1968, or 1969 1st gen Camaro!
|Chevrolet||Camaro||1967 - 1969|
Note: HTML is not translated!
Rating: Bad Good