Model: | 2028929 |
Condition: | NEW |
Availability: | YES, IT'S IN STOCK! Units in stock: 5 Ships within 24 - 48 hours Available for Pickup |
Fitment: | Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle. |
Shipping Note: | Standard Delivery |
Qty: |
We'll find it for you. Give us a call at 877.589.9860 and we'll source that discontinued or hard to find part.
No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.
Camaro Depot always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.
Reproduction of Original Correct Height, Length and Profile 13 Clips Per Set End Clips Sold Separately as Part # WM-8 Replacement Pin Studs Available Separately as Part # WM-40 Fits 1967-1969 1st Gen Coupes The molding clips for your 1967, 1968, or 1969 first generation Camaro's windshield can often become cracked, brittle, or go missing over the years. The clips and pin studs at the windshield area are also prone to rust due to constant exposure to the elements. This all leaves your windshield moldings unprotected and unable to do their job fully. Rick's Camaros offers this set of reproduction clips which will attach the upper and side windshield moldings to the pin studs on the upper and side of the windshield frame on your Camaro F-Body Coupe. This set comes with 13 clips, all the correct height and length for your Coupe. From racers, show cars, hot rods, and daily drivers, you can trust Rick's Camaros for all of your restoration and replacement needs for your 1967, 1968, or 1969 1st gen Camaro Coupe!
Make | Model | Years |
Chevrolet | Camaro | 1967 - 1969 |
Your Name:
Your Review:
Note: HTML is not translated!
Rating: Bad Good