LOW STOCK ALERT!
Units in stock: 3
Ships within 24 - 48 hours
Available for Pickup
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
|Shipping Note:||Oversize 2|
We'll find it for you. Give us a call at 877.589.9860 and we'll source that discontinued or hard to find part.
No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.
Camaro Depot always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.
Officially Licensed Reproduction Show Quality Exact Duplicate Of Original GM Smooth & Contoured End Points Highly Polished Mounting Bracket & Hardware Included Fits Left Or Right Side Doesn't Fit 1968 Rally Sport These lower rocker panel moldings are simply the best reproductions available for your 1967, 1968, or 1969 First Generation Camaro. Other lower quality and less expensive reproductions out there are not made of the same material and the end points end up blunt, cut jagged or incorrectly bent. Rick's Camaros is proud to offer the best reproduction for your Camaro which includes the large mount bracket and hardware to make installation simple. These show quality moldings are highly polished, have smooth and contoured end points, and include the mounting bracket and extra hardware. When your rocker panel moldings became worn and cracked or fall off, it is time to replace them with these superior moldings. Trust Rick's Camaros for all of your restoration and replacement needs for your 1967, 1968, or 1969 Camaro! NOTE: This molding is used on all 1967-1969 Camaros except the 1968 Rallysport.
|Chevrolet||Camaro||1967 - 1969|
Note: HTML is not translated!
Rating: Bad Good