Estimated arrival: 11/04/2020 (If Ordered Today)
Select a Vehicle or refer to the Vehicle Fitment Tab below to verify that this part fits your vehicle.
|Shipping Note:||Standard Delivery|
We'll find it for you. Give us a call at 877.589.9860 and we'll source that discontinued or hard to find part.
No Brokerage or Duties - Canadian Owned & Operated - Shipped from Canada to your Door - Easy to Navigate Website - Access to New, Used & Discontinued Parts - Full Time Staff to Answer your Questions.
Camaro Depot always recommends professional installation of our products. Buyer assumes risk of damage caused by improper installation.
Torque Arm Benefits:
Rear Torque Arm Hardware Kit – Through bolt rear axle housings require UMI P/N 3003 to complete installation on factory housings, Strange, Moser 9” and most other housings. UMI P/N 2998 should be used on Moser 12-bolt with the four bolt mount design.
UMI's 2236 weld-in torque arm is a great way to get UMI quality and performance in your 3rd and 4th Gen F-body. The shortened torque arm length improves instant center and provides reduced 60 ft times and enhanced forward traction. The adjustment feature allows for optimizing the pinion angle and ensures a vibration-free driveline at any ride height. The #2236 unit is designed with a straight front cross member to clear tight fitting header/y-pipe set-ups. Since crossmember installation is weld in you have the ability to raise or lower crossmember before welding for perfect clearance. Installation note: Crossmember installation requires welding and cutting to complete installation. Torque arm must be installed with 2-point subframe connectors.
|Chevrolet||Camaro||1982 - 1987|
Note: HTML is not translated!
Rating: Bad Good